|
|||||||
|
|
|
|||||
|
|
|||||||
Here is a picture of the Handle assembly with the Electronics installed.
You will notice that the battery box is held in place by 4 plastic tie straps. This was done because I have not yet fabricated a bracket or mount for it ,yet. The 4 straps do seam to be holding it quite well at this time. Take notice that I drilled through both sides of the handels to mount the "trigger" switches. I just mounted the switches and let the wires pass through the other side.
I wrapped all exposed wires with elec. tape. The wires that run along the rod between the handles were wrapped to the rod with more tape. Note: the wires MUST NOT be place in such a way that they will get cut by the large hose clamp that will be used to hold the whole thing on to the gun.(think ahead). The small piece of wire that sticks off the end of the assembly go's to the solenoid on the valve.
Spud Gun Improvements to Pneumatic Gun
Spud Gun Theory of Operation
Spud Gun How Much Does IT Cost
Spud Gun Barrel Adapter Assm
Spud Gun Barrel Air Chamber Assm
Spud Gun Air Control Assm
Spud Gun Air Gauge Assm.
Spud Gun Drilling of Clean Out Cap
Spud Gun Handle Assm. with Electronics
Spud Gun Handle Assm
Spud Gun Piston Stopper Assm
Spud Gun Wiring Digram