|
|||||||
|
|
|
|||||
|
|
|||||||
This is pretty self-explanatory for the most part.
Note that the on/off rocker switch is mounted in the side of the battery box.The battery box is a small plastic box I found at Radio Shack. I took three 9-volt batteries rapped a few layers of tape around them(they will all be replaced at the same time)and used some velcro cloth(about 2" x 3/4") with sticky tape on the back side of both pieces. I stuck this to the batteries and the batteries to the inside of the box.
The battery box hides the batteries and gives the gun a cleaner look.Wrap all exposed wires with electrical tape and or cover with automotive wire loom (wire loom looks good and gives that HI-TECH look, oh yea it also helps protect the wires from damage)
Also at Radio Shack I found a 5 pack of the clips that go on the top of the batteries with about 5" of red and black wire on each for under 2 bucks.(very handy)
I used the spade connectors on the wiring to the solenoid so that I could disconnect them when I had to unscrew the cap off the clean out to make repairs or clean the gun. (I have had to remove it about 5 times so far.)
Spud Gun Improvements to Pneumatic Gun
Spud Gun Theory of Operation
Spud Gun How Much Does IT Cost
Spud Gun Barrel Adapter Assm
Spud Gun Barrel Air Chamber Assm
Spud Gun Air Control Assm
Spud Gun Air Gauge Assm.
Spud Gun Drilling of Clean Out Cap
Spud Gun Handle Assm. with Electronics
Spud Gun Handle Assm
Spud Gun Piston Stopper Assm
Spud Gun Wiring Digram